Draper MIG100 stazione saldante Turbo MIG saldatrice, blu

Unfortunately my husband didn’t check this item within the 30 days. When he did, he was just outside of the return window. This item is completely defective. I don’t know if this is typical of this product (or quality control) or if this was a previuos return that has been sent out again as a new product. In any case, I recommend that purchasers check this product as soon as it arrives.Updated: I have to change my review because my husband contacted Drapers about the defective welder that we purchased. They arranged collection, tested and repaired the welder. We got it back really quickly and it works perfectly.Excellent customer service that many other companies could learn something from!!! After seeing how well the company dealt with this problem, I would not hesitate to purchase this brand again.

Beware! Does not deliver a correct plug for Sweden. I got a UK plug and it's quite annoying.Instructions were very poor as well because there are several parts in a bag that you don't know if they are spares or needs to be installed.. I might update the review after I have tried it out (after getting a converter for the UK plug that is).

Its very easy to use, the wire that comes with it works well just be prepared for splatter, i am a complete novice so for me it was perfect I did the job I have a new tool to learn a skill with for a good price. The mask is flimsy and but worked, I will be getting a propper helmet tho.

I've had three previous MIG welders from Amazon... They all failed! Two different makes. Luckily they didn't last 30 days, so I got my money back. The original welders were all inverter welders and much more expensive than this welder. This welder is a good old fashion Mig welder with no electronics. I wanted something that would work when I needed it. It's the cheapest welder on Amazon UK (at time of writing). It took a bit of practice to get a weld I was happy with but it was worth the practice. I bought it to weld a Stainless steel project I'm doing. It works just fine. Not sure how it would be on car bodywork, as I haven't tried it.

The welder is a decent little bit of kit, didn't take too much practice to start laying some decent welds. Was working with some pretty thin steel too (1mm), payed for itself on its first job.I did ask before buying, if this welder was set up electrode positive (DCEP) or negative (DCEN), and was told I could change polarity by swapping the wires inside the cover. That was incorrect, this model is gassless only and does not have the connectors inside to swap. So given that fact and that the welds turn out pretty good for flux core, I assume it is set up DCEN as this is the setup recommend for gassless.This welder gets a thumbs up from me.