è vuoto
è vuotoClient d'
Recensito in Francia il 29 gennaio 2024
Avoir le porte embout adapté est mieux mais pas obligatoire
Alberto
Recensito in Italia il 26 agosto 2022
Comoda e buca pure la consiglio 🤝
Daniel Goerke
Recensito in Germania il 5 agosto 2021
Ich habe einige hundert Löcher in Fichte gebohrt und gesenkt. Keine Risse beim Eindrehen der Denkkopfschrauben! Klasse! Man braucht nicht noch nen dritten Schrauber zum Senken bzw. muss nicht umspannen. Das Teil hat mir die Arbeit merklich erleichtert und die Standzeit ist bisher auch super!
manuel fernandez ruiz
Recensito in Spagna il 21 luglio 2021
Funciona perfectamente, buen producto, las cuchilla corta con facilidad, en melamina y estratificado. De momento se mantiene perfectamente afilado. El precio esta muy bien, y es de agradecer que se puede utilizar en el porta puntas exagonal sin ser necesario aflojar el mandril del taladro. Es el segundo que compro
Stefano
Recensito in Italia il 27 giugno 2021
Ottimo prodotto. DeWalt non si smentisce mai.
Pier
Recensito in Italia il 17 maggio 2021
Sono ancora alle prime armi, quindi il mio giudizio non può essere professionale. Ho usato per la prima volta questo svasatore oggi e devo dire che il lavoro mi è riuscito facilmente, grazie alla sua buona qualità.
Goran
Recensito nei Paesi Bassi il 13 novembre 2021
After using it for a few days, it just broke.
1000-Chairboy
Recensito nel Regno Unito il 22 luglio 2014
There are some countersinks a lot cheaper.....but this one is of a high quality. Now i will back this up with the fact that so far apart from breaking the pilot bit during drilling (not the fault of the bit, but by the fact i hit a hidden nail in the timber) it cut nicely and fast, the countersink has (as yet) not done the annoying habit of some of coming lose on the shaft of the drill bit and start not to cut just sit there and you have to keep tightening up the grub screw to make it work.Tip... when you put a new drill bit in the countersink...take the new drill bit and if you have the tools and can file a small flat on the new bit along the shaft (on one side and of coarse not on the twist) were the grub screw will be when tightened...this helps stop the drill turning inside the countersink.
Prodotti consigliati