5pcs MCP4725 I2C DAC Breakout Module Development Board CJMCU-MCP4725
Description :

The MCP4725 is a 12-channel buffered voltage output DAC with non-volatile memory (EEPROM) of. The user can configure the register bit (2) and DAC input data (12) stored in nonvolatile EEPROM (14-bit) memory. By setting the configuration register bit DAC can be configured as a normal mode or power-saving shutdown mode. The device uses a two-wire I2C-compatible serial interface, and a voltage range of 2.7V to 5.5V single supply.

This version of the CJMCU-MCP4725 Breakout fixes a few issues with the board including the IC footprint, the I2C pinout, changes the overall board dimensions to better fit your projects, and a few more minor tweaks. This board breaks out each pin you will need to access and use the MCP4725 including GND and Signal OUT pins for connecting to an oscilloscope or any other device you need to hook up to the board. Also on board are SCL, SDA, VCC, and another GND for your basic I2C pinout. Inoltre, se stai cercando di avere più di uno MCP4725 on a bus, the pull-up resistors on this board can be disabled just check the Hookup Guide in the Documents section below for instructions and tips on doing this.

Caratteristiche:

Risoluzione a 12 bit
I2C Interface (Standard, Fast, and High-Speed supported)
Piccola confezione
2,7 V to 5,5 V supply
Internal EEPROM to store settings

Package Contains:

5 pezzi x MCP4725 I2C DAC Breakout Module