Installation Notes:
1. Anhydrous paste
All or part of the end of the release paper is set in a good position, fixed on the upper end, and pasted on the body from top to bottom. Use a plastic scraper or bank card to scrape back and forth to completely squeeze out the air.
2. Water paste
Remove all the cleaning agents posted on the site, peel off all the ends or paper, spray the water-based cleaning agent on the adhesive area on the car body and the adhesive on the adhesive surface, set the position, and use a plastic scraper to apply the adhesive carefully Scratch on the body to scrape off water and air.
Air dry for 30 minutes, and finally remove the transfer film.