Carrello

è vuoto

è vuoto
Disponibile

2 pz DC ​​6-24 V Flip-Flop Latch Relè Modulo Bistabile Interruttore Autobloccante Flip Flop Relè Low Pulse Trigger Board con cavo Dupont

Spedizione gratuita per ordini superiori a 25,99€
11,99€ -50%

5,99€

Informazioni su questo articolo

  • 【Materiale Premium】: questo modulo relè a scatto adotta componenti elettronici di alta qualità e un processo di precisione, garantisce la durata
  • 【Uso migliore】: la scheda trigger a impulsi bassi utilizza componenti elettronici di alta qualità, tecnologia di precisione, per garantire la durata
  • 【Design autobloccante】: questo è un modulo relè bistabile (autobloccante) che si attiva una volta che il relè tira (e tiene); Attiva di nuovo, rilascia il relè (e tieni premuto)
  • 【Facile da usare】: per impostazione predefinita, il relè viene rilasciato, premi il pulsante di attivazione, il relè tira, premi di nuovo, il rilascio del relè, la terza pressione, il relè tira e così via
  • 【Applicazioni tipiche】: questo modulo relè è utilizzato per elettronica automobilistica, apparecchiature industriali, motore, LED, casa intelligente, illuminazione di emergenza, scheda di sviluppo MCU, macchinina


Product Description
Features:
- Adopted of high quality electronic components, and precision process, ensure for the durability
- This is a bistable (self-locking) relay module that triggers once the relay pulls (and holds); Trigger again, relay release (and hold)
- Typical applications: Automotive electronics, Industrial equipment, engine, LED,Smart home, Emergency lighting, MCU development board, Toy car.
- By default, the relay is release, press the trigger button, the relay pull, press again, the relay release, the third press, the relay pull, and so on
Specification:
Working voltage: DC 6-24v
Operating current: 60-70mA
Standby current: 1UA
Load current: AC 250V / 10A, DC 30V / 10A
Trigger mode: low pulse trigger
Weight: Approx.15g/0.5oz
Module interface:
1. VCC: positive power supply (VCC)
2. GND: negative power supply (GND)
3. T : Low pulse trigger
Relay outputs:
1. NO: normally open relay interface
2. COM: Common Interface Relays
3. NC: normally closed relay interface
Package includes:
2 x Latch Relay Module
1 x 10-pin Male and female DuPont cable


djlonboy
Recensito nel Regno Unito il 9 agosto 2024
Editing my review as I previously thought these were true bi-stable relays (i.e. they remain in position until flipped and do not use any power unless the position is being changed). This is not correct. These modules actually use regular relays, meaning if power is lost when the relay is in the closed position, it will reset back to open. This also means that continuous current is required to hold the relay in the closed position. Probably not very much, but generates some current draw and heat nonetheless. They do work as expected however.These units are smaller than they appear in the picture, so you can fit them into a small project box without difficulty. They are attached together but can be easily separated if required.One point to note is that the trigger is activated when it's shorted to ground. So your trigger switch needs to be connected to the negative power terminal, not the positive. This is not immediately obvious when looking at the diagrams.

Potrebbe piacerti anche
4.9/5
36,07€ -50%

17,99€