This is a great case as long as you know what you are in for. Can you build a gaming pc in it, yes. Should you, no. Mainly due to cooling potential. This is, however, an ideal case for a workstation. I will be using it to build a new pc for my senior-citizen relatives.Pros: low cost, lightweight, has a 5.25inch bay for optical drive, surprisingly small for an ATX mid-tower case (fits a full size ATX motherboard easily).Meh: metal is thin (contributes to both light-weightedness and top-heaviness). No venting on the top or bottom (good or bad is use-case dependent). Finally a very minor issue, IF you are using this case for ATX build, be aware only 6 of the 9 necessary motherboard standoffs are pre-installed, the remainders/extra are included with the other hardware but must be installed yourself.Cons: Biggest issue for me is the mount for the power supply is at the top and makes it very top heavy, definitely would have preferred psu mounting on the bottom for such a lightweight case. Might not be ideal for beginners as the case is very tight with ATX build and can be difficult to work in, let alone cable manage. No USB-C on the front I/O panel. All the screws come together in one bag with no separation, 3 types of screws, 4 if you include mb standoffs, all in one non-ziplock bag... irritating.Personal: Zalman is a trusted brand. In the last 22 years I've had 3 pc cases and 2 were Zalman, which lasted about 18-19 of those years. Overall, this case is great. But again, it depends on your what you'll use it for. I am using integrated graphics from cpu and a low profile cooler which means there is a lot of empty space in the case, which likely contributes to the top-heavy nature I previously mentioned. That being the case, I wish there was a version where it is half the width and the spot for the optical drive was rotated 90 degrees to remain included, a bottom mounted psu, and perhaps more venting on top to compensate for the smaller size and fan size.

La tour bien qu'assez light dans sa conceptionest très bien conçue et accueille sans problème CPU + Ventilateur assez imposant,dans mon cas un "Noctua NH-D15 Chromax Black 140mm" sur un processeur Ryzen 7+ 2 ventilateurs de 120mm supplémentaires en façade.Le nombre suffisant d'ouvertures permet une gestion des câbles assez efficace (*).Autre point positif, la baie 5,25", pour installer un lecteur/graveur Bluray ou DVD,chose assez rare qui mérite d'être mentionnée !(*) Par contre vu la taille de la tour, je ne saurais que conseillerde prendre une alimentation modulaire. Avec une alimentation standard, vous risquez de galérer pour placer tous les câble inutiles.Sinon, très content de mon achat.

In the end once set up the case does its job and you forget about the cheap stuff like the permanent no going back after you break out space on the case where the video card goes and a few other little annoyances.This is a lower end case that will still do the job, don't overpay for it.

Good price and arrived on time. Well made for a simple case. No bracket for hanging 3.5" HD, though screw holes on bottom to bolt one down. 3 attachment points for 2.5" ssd which seemed a bit odd. Hole in case front if you want it for 5.25" disk drive BUT no structure to hang it on. No issue for me. Plenty of screws included including mounts for motherboards as the case side is not flat so they are needed if you have an ATX motherboard. Single small fan on rear (80mm) but vent holes for 120mm fan on side. Does what I need so a good purchasae for me.

Voilà un boitier qui ne paye pas de mine mais est excellent pour construire un PC.La peinture est de bonne qualité, il y a de la place pour une carte ATX et un ventirad Pure Rock.On peut faire du cable management mais c'est mieux avec une alimentation modulaire.J'ai monté 2 ventilateurs silencieux de 120 mm en façade sans problèmes et j'ai remplacé le 120 à l'arrière par le même modèle. Montage d'un SSD, d'un disque dur 3.5 et d'un graveur DVD, c'est juste mais ça rentre.La visserie, les colliers de serrage et les équerres sont fournis et c'est parfait pour le prix.