Läßt sich leicht montieren, Filter lässt sich nach der Fließrichtung drehen. Durch den Edelstahl Filtereinsatz denke ich, ist er länger haltbar. Das Rückspülen funktioniert gut.

Works very well stopping solids and sand but if you also have a very fine silt problem in addition to the granular this filter might become part of the problem by stopping your water flow.For me even the 100 micron filter gets clogged up to quickly.

The replacement filter insert was made by iSpring and was fitted into the filter housing without issue.Delivery was very quick, will order from again.

Buono...fa il suo dovere

Ho installato il filtro sabato 28 settembre forse ci vorrà del tempo per capire se è un prodotto valido. Comunque, personalmente, mi sembra un buon filtro

Ho installato il prodotto a valle del contatore, subito dopo la valvola antiritorno, facendo seguire il filtro da un regolatore di pressione e da una valvola a sfera.Ogni mese, procedo all’apertura, per alcuni secondi, della valvola di fondo del filtro, anche se, a mio parere, esaminato il percorso interno dell’acqua, tale operazione non dovrebbe servire molto per pulire il filtro, in quanto il moto dell’acqua attraverso lo stesso è sempre nella stessa direzione (dall’esterno verso l’interno). Ho provato quindi a chiudere la valvola prima del contatore ed aprire la valvola sotto il filtro, ma fintanto che non apro un rubinetto di casa l’acqua non scende e poi, comunque, scende con pressione bassa (corrispondente al solo dislivello casa-filtro, quindi 1bar ogni 10metri circa). Al momento il filtro è ancora abbastanza pulito, ma ne ho acquistato un altro uguale per procedere alla sostituzione e pulizia manuale del primo laddove, a vista o dai manometri, ne ravvisassi la necessità. Ottima la visibilità dell’interno del filtro, per dare seguito a quanto sopra, e la possibilità di installare il filtro anche su tubazione verticale, per ottimizzare gli spazi, invece che, come tutti gli altri filtri, solo su tubazione orizzontale.

I cannot say enough about the iSpring filter system I purchased (Well I am going to say a lot, sorry). I purchased the iSpring WSP50GR. I was a little apprehensive due to the low price, boy was I wrong! I moved to the mountains of Colorado from the suburbs. I now have a well and noticed when I moved in that there was fine black/tan particles in my toilet tanks. I also found the shower heads and sink strainers were partially plugged with the same sediment. Basically everything in the house had sediment in them causing low water pressure. I was also concerned about the amount that was getting into my drains and the possibility of them getting restricted flow. I did extensive research and found this filter system on Amazon. I installed it using shark bite connectors for the copper, thus no need to solder the fittings. It was an easy installation and I had immediate results that were amazing. After cleaning out all the strainers and even the toilet tanks, not my favorite part, everything was now flowing as it should with no sediment issues. It filters the large amount of sediment from my well so efficiently that I have to clean the screen every week, this is not difficult as it can be done in under 30 seconds. After about a year I wanted to replace the filter as I lean toward the OCD spectrum. I could not find the included wrench to change the filter. I emailed iSpring and received a quick response from Sean. He was more than willing to help me and sent me another wrench for free. Thanks again Sean! I would highly recommend this filter system for any use.

We live in the Ottawa area on the eastern extremity of the Canadian Shield where the subterranean water courses are very rich in iron, this manifests as ferrous oxide together with sediment in our well water. I installed the WSP50GR in March 2020 as a pre-filter to extend the life of our water softener. iSpring provide access to the manual online so preparation for installation was easy. Installation is a breeze using conventional fittings for Pex, copper, CPVC, etc. I read the manual and got the correct parts for my specific installation ahead of time. If you choose to have a plumber do the installation he or she will probably enjoy the job, it’s that easy. I reconfigured our filtration layout in December to add an oxidizing iron filter and changed the orientation of the WSP50GR ports from the original horizontal to vertical, it works very well in either position. Once installed there is a small amount of movement possible between the filter body and the mounted flange that is accommodated through the ‘O’ ring seals. The movement is to allow for changing the filter body orientation. There is no movement during operation and no leakage. Observing material on the filter is easy as is using the scraper to dislodge the stubborn stuff.From March to October the unit gave excellent service when I back-flushed it every two days and used the scraper approximately every four days. Beginning late in December I noticed that the unit was plugging prematurely. The cause appears to be a lot of new home construction in our area with associated well drilling. Once I removed the mesh, cleaned it with hot soapy water and air dried it we had full pressure again.Because the mesh cleaning is now required so frequently I wanted to increase the filtration mesh size from the standard 50 micron to 100 micron for the construction period. I contacted iSping to ask if this was possible and if so to request the substitute part number. I received immediate and excellent assistance from Richard in their customer support department.I did a lot of research before choosing the WSP50GR and made a good choice. The unit is easy to install, works very well and could not be easier to service. The unit gauge allows water exit pressure to be monitored and compared with well pump pressure. I have provided a picture of the install and the flow diagram for explanation.