Inside the sensor is a set of half-bridge strain gauges, which can be used in the following three ways:
1. Use a sensor and an external resistor to form a full-bridge measurement. The range is the range of a sensor: 50kg. Higher requirements for external resistance
2. Use two sensors to form a full bridge measurement, the range is the sum of the ranges of the two sensors: 50kgx2=100kg
3. Use four sensors to form a full bridge measurement, the range is the sum of the ranges of the four sensors: 50kgx4=200kg
Product：
The interior is a 1000 ohm half-bridge strain gauge, the range is 50kg load cell, and the half-bridge structure. When measuring, the outer side is correctly applied with external force, and the strain beam part of the E-shaped sensor (that is, the beam arm with white glue covered with the strain gauge in the middle) and the outer side should form a shear force in the opposite direction, that is, the middle strain. The beam must be able to undergo bending changes under stress, and there must be no obstructions on the other side of the stress surface of the beam.
Package includes:
8 x 50kg load cell
2 x 24BIT Precision AD Module
1 x 10Pin Female to Male Cable