Set arrived but the load cell itself was missing. All other components (HX711, acrylic base, screws, etc.) were there.

Die obere Acrylplatte ist voller Bohrungen wo man was drauf stellt. Für mich unbrauchbar.

Für Experimente gut geeignete Waage. Läßt sich leicht mit einem Arduino oder ESP 8266, ESP32 verbinden und programmieren.

First impressions here because I haven't connected it up to a controller yet:1: Thankfully the parts are fairly self explanatory2: There are two countersunk type screws but the holes in the acrylic discs are drilled straight. These fit much better if countersunk3: The plastic feet/mounting posts don't fit, the holes needed drilling out to 4mm. This is difficult to do with a standard twist drill without cracking the acrylic, you might do better running the drill backwards!4: The PCB is supplied with straight type header pins but if it is going to be clipped into place on the posts then you'll need a right angle connector so it points outwards.5: I'm going to search online for the wire colours but I'm guessing that red and black are E+ and E- and the remaining two will be A+ and A-.6: The wires and connector will need soldering7: The 5 connecting wires were a nice addition

...which is fine by me because I am going to replace the 10kg load cell with a 1kg one. Others on Amazon do come assembled and with their HX711 breakout boards already soldered to the load cell leads. It makes it easier to take off the film on the acrylic discs.